Pontiac G8 Forum banner
1 - 1 of 1 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
Hey all. To anyone else that has installed the Roto-Fab CAI did the 3/8" hose that connects to the passenger side valve cover come extremely close to the tensioner/idler pulley when you installed it ? When I initially installed it it was rubbing so I twisted the hose a little and that got it off the pulley but it still made me nervous. I ended up using a zip-tie to get it back about a half inch.

Maybe I routed it wrong but the installation instructions said to route it under the throttle body motor, which is what I did.

If anyone has a pic of the way they routed it it would be much appreciated, just for a comparison.

~ Jerry
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.